Products/BlueSense/Lamp
From BlueMelon
Requirements
- BM7002 Bluesense digital outputs
- Lamp
- Wires
- Adaptors
- Soldering iron and tin
- BM6104 Screwdriver set
Connecting
To connect the lamp to a BM7002 Bluesense digital outputs, you solder 1 wire to the tip of the lamp and one to the side. The wire which is attached to the side of the lamp can be connected to any of the numbers (1-8). The wire which is attached to the tip of the lamp should be connected to the (+) on the same side of the board as the first wire. Connect the marked wire of the adaptor to the same (+) as the wire of the tip of the lamp. Connect the other wire of the adapter to the (-).
Be sure all wire tips are stripped before screwing them in the terminals or soldering them! Plastic doesn't conduct electricity very well...
Software and documentation
- BlueSense downloads
- Bluesense FAQ
- Tutorials and general information can be found on the following page: Information and examples
Examples
Below you can find examples of how to use the module in several programming environments. If there is no example you can look into the API reference manual.
![]() | ![]() | ![]() | ![]() | ![]() | ![]() | ||||
|---|---|---|---|---|---|---|---|---|---|
![]() | X | X | X | X | X | X | X | X | How to switch devices |
| X | X | X | X | X | X | X | X | PWM example (dimmer) |
Relevant products
| BM7002 Bluesense digital outputs 16 open collector digital outputs (with PWM support) | € 69,- |
| Adaptors | ||
| € 5,- | ||
| € 7,50 | ||
| € 8,50 | ||
| BM6104 Screwdriver set Screwdriver set to (un)screw terminal blocks on BlueSense modules. | € 5,- |









